Connection Of Calibration Mixer (With If Filter) - Agilent Technologies E5071C Manual

Hide thumbs Also See for E5071C:

Table of Contents

must also set the minimum IF frequency at more than 0 kHz.

IF BW must be set to much smaller value than IF frequency.

5. Selecting a Calibration Kit

Select a calibration kit (3 in menu).

The mechanical calibration kit displayed in the Vector Mixer

Characterization macro is the frequency registered in the

E5071C and read from it. If an ECal module is connected to the

E5071C, ECal will be selected automatically.

6. Measuring Calibration Mixer with IF Filter (when using calibration kit)

Connect the calibration mixer to one of the test ports on which 1-port

calibration has been done, as shown in the following figure.

Connection of calibration mixer (with IF filter)

1. Select any port if full 2-port calibration is set.

2. We recommend that you characterize the calibration mixer with

an IF filter when the power splitter for distributing the LO signal

is connected to the measured mixer. In vector-mixer calibration,

Show Quick Links

Table of Contents