Displaying Ripple Test Results - Agilent Technologies E5071C Manual

E5071C

Displaying Ripple Test Results

Measurement point and test results
Failed measurement points will be displayed in red on the screen. The test
result for the trace will be indicated as Pass or Fail in the upper-right area
of the graph. You can also display the ripple value at the selected
frequency band.
The result will be displayed as Ripln:Pass (or Fail) for each trace. n denotes
the trace number. Bn will be followed by the ripple value (if the ripple
display is turned off, only Bn will be displayed without the ripple value).
For example, in the following figure, Ripl1:Pass in the first line indicates
the result for trace 1. The value following B3 is the ripple value at the third
frequency band specified in the ripple test. Similarly, the second line
indicates the test result for trace 2, showing the ripple value at the first
frequency band.
For information on how to display the results, see Turning on/off ripple test
and displaying results.
Test result for channel
If a channel has a judgment result of "fail," the message will be displayed
as shown in Test Result for Trace. (It will be judged as failed if one or more
failed traces are found in the limit test, ripple test, or bandwidth test within
the channel.)
320