Code Migration Tools; Code Conversion Assistant Editor; Ena 8753 Code Translator (Ena8753Cxl) Application - Agilent Technologies E5071C Manual

E5071C

Code Migration Tools

This section provides useful information to migrate the automation system
from 8753 to ENA.

Code Conversion Assistant Editor

•

ENA 8753 Code Translator (ENA8753cXL) Application

•
Other topics about Replacing 8753ES with E5071C
Code Conversion Assistant Editor
The code conversion assistant editor helps to convert 8753 GPIB
commands to ENA commands. This software consists of a text editor
(EmEditor) and a plug-in software, which works on a PC and helps to edit
programs in text format. The editor is also useful for 872X analyzers as
most of the 872X commands are the same as 8753's. The software can be
downloaded from www.agilent.com/find/ena_support.
ENA 8753 Code Translator (ENA8753cXL) Application
The ENA8753cXL is a code emulation application that allows you to use the
ENA with the test program that was written in language for 8753 series
network analyzer. This application works on background of the ENA,
translating incoming 8753 commands via GPIB in real time.
The ENA8753cXL is designed to work with certain legacy Agilent
•
Network Analyzer products. Not all products may be supported
nor can all legacy commands be supported. ALWAYS REFER TO
THE INFORMATION PROVIDED IN THE HELP FILE FOR
ADDITIONAL INFORMATION REGARDING THE LIST OF
SUPPORTED COMMANDS AND PRODUCTS.
On the HDD revision CN920 or above, the installer is pre-loaded on the
ENA HDD image (D:\Agilent\ENACXL\Agilent_ENA8753CXL.msi). To install
the ENA8753cXL application, follow the instruction below.
If the HDD revision is less than CN920, contact your nearest
•
Agilent Technologies sales representative.
1. Terminate the ENA application: Press
2. Double-click the Agilent_ENA8753CXL.msi to launch the installer
3. Follow the wizard to install the ENA8753cXL
After the installation is complete, the following files will be available from
the Windows start menu. Refer to the "Help Manual" for more details on
launching and using the ENA8753cXL.
910
key, click Service > Exit
System