Safety Summary - Agilent Technologies E5071C Manual

E5071C
Safety

Safety Summary

The following general safety precautions must be observed during all
phases of operation, service, and repair of this instrument. Failure to
comply with these precautions or with specific WARNINGS elsewhere in this
manual may impair the protection provided by the equipment. Such
noncompliance would also violate safety standards of design, manufacture,
and intended use of the instrument. Agilent Technologies assumes no
liability for the customer's failure to comply with these precautions.
The E5071C complies with INSTALLATION CATEGORY II as well
•
as POLLUTION DEGREE 2 in IEC61010-1. The E5071C is an
INDOOR USE product.
The LEDs in the E5071C are Class 1 in accordance with
•
IEC60825-1, CLASS 1 LED PRODUCT
Ground the Instrument
•
To avoid electric shock, the instrument chassis and cabinet must be
grounded with the supplied power cable's grounding prong.
DO NOT Operate in an Explosive Atmosphere
•
Do not operate the instrument in the presence of inflammable gasses
or fumes. Operation of any electrical instrument in such an
environment clearly constitutes a safety hazard.
Keep Away from Live Circuits
•
Operators must not remove instrument covers. Component
replacement and internal adjustments must be made by qualified
maintenance personnel. Do not replace components with the power
cable connected. Under certain conditions, dangerous voltage levels
may remain even after the power cable has been disconnected. To
avoid injuries, always disconnect the power and discharge circuits
before touching them.
DO NOT Service or Adjust the Instrument Alone
•
Do not attempt internal service or adjustment unless another person,
capable of rendering first aid and resuscitation, is present.
DO NOT Substitute Parts or Modify the Instrument
•
To avoid the danger of introducing additional hazards, do not install
10