Agilent Technologies E5071C Manual page 763

E5071C
OUTPUT command of HTBasic automatically sends the message terminator
after the last data byte.
Parameters
A space (ASCII code: 32) is required between a command and its first
parameter. When sending several parameters in a single command,
separate each parameter with a comma (,).
Message including several commands
When sending 2 or more commands in a single message, separate each
command with a semicolon (;). The following example shows how to send
the command and the
*CLS
using HTBasic.
OUTPUT 717;"*CLS;:STAT:PRES"
Remote Mode
The E5071C does not provide remote mode. Therefore, even if you send a
GPIB command, it never enters into remote mode automatically. There is
no local key to release remote mode.
If you need to prevent misoperation during remote control due to entry
from the front panel or mouse, lock the input devices using the following
commands.
•
:SYST:KLOC:KBD
•
:SYST:KLOC:MOUS
990
command in a single message
:STAT:PRES