STEP 2. Setting Measurement Conditions
Before starting the measurement, you must set measurement parameters and sweep
conditions depending on your measurement requirements. This section describes the setup
procedure for the following four measurements.
(1) Frequency characteristics of |Z|-Ls-Q
(2) Frequency characteristics of |Z|-R-X
(3) Oscillator level (current) characteristics of Ls-Q
(4) Dc bias (current) characteristics of Ls-Q
The procedure for measurement example (1) is carried out by using the mouse and
keyboard as well as front panel keys. The procedures for measurement examples (2), (3)
and (4) are carried out by using the mouse and keyboard only.
NOTE
When measuring a capacitor, the OSC level (voltage) and dc bias (voltage) characteristics
are used.
Flow for Setting Measurement Conditions
The basic procedure for setting the measurement conditions is illustrated in Figure 3-4.
Figure 3-4
Basic flow for setting measurement conditions
Chapter 3
Basic Operations for RF Devices Measurement
STEP 2. Setting Measurement Conditions
45