Setting Up An Autotest; Opening The Setup Menu; Choosing The Profile; Choosing The Standard - Agilent Technologies WireScope 350 User Manual

8r…‡vs’vtÃ8‚ƒƒr…Ã8hiyvt
Tr‡‡vtÃVƒÃhÃ6ˆ‡‚‡r†‡

Setting Up an Autotest

Opening the Setup Menu

.

Choosing the Profile

Choosing the Standard

3−4
The tester must be configured for testing at each site by completing the
following procedures.
1 On the Main Menu, press Setup. The Autotest Setup screen displays.
The WireScope 350 normally displays one or two limit options on the
Main Menu, based upon the profile selected. If None is selected, then the
two limit options are dependent upon the Standard selected. If the
Standard is TIA-568B, then the two limit options are Category 5E and
Category 6. Otherwise Class D and Class E are displayed. If the profile
for a specific test is selected, then only that test choice is displayed. To
change the profile:
1 On the Autotest Setup screen, press Profile, then Edit. The Profile
Setup screen displays.
2 Press None, or the profile of choice, then press OK. The Autotest
Setup screen will then show your selected profile.
The WireScope 350 normally tests to the TIA-568B standard. (For
detailed information about test standards, please visit the website at:
http://wirescope.comms.agilent.com/ ) To test to a different standard,
follow these steps:
1RWH
UurÃQ…‚svyrÀˆ†‡ÃirÆr‡Ã‡‚ÃI‚rÃvÃ‚…qr…Ç‚ÃpuhtrÇurÃT‡hqh…q