Setting Channel Display (Layout Of Channels) - Agilent Technologies E5071C Manual

E5071C
72
96
160
Its important to realize that the combination used to save a state file
•
must be the same used to recall it; that is, you cannot save a state file
with one combination of channels/traces and recall it with another
combination. For more details, see Saving and Recalling Instrument
State.
The selection procedure is as follows:
1. Press
System
Menu > Channel/Trace Setup for some settings)
2. Press the desired softkey to select the upper limits of the number of
channels and the number of traces.
3. The dialog box that prompts "New Channel/Trace configuration will
take effect after firmware restart." appears.
4. Click OK.
5. Press any softkeys or hardkeys besides
6. The dialog box that prompts "Do you want to restart now?" appears.
7. Click Yes.
8. On choosing a multi-channel mode, it may take more time to restart
the firmware. The screen may seem to freeze but will resume their
normal operation once the settings are applied.

Setting Channel Display (Layout of Channels)

The measurement result for each channel is displayed in its dedicated
window (channel window). You cannot have a single window display the
measurement results from more than one channel. This means that the
74
9 401
9 201
9 201
> Misc Setup > Channel/Trace Setup.
From For these setup,
A.08.10 press
System
Service Menu >
Channel/Trace
Setup
After the
configuration
setup is
applied,
memory swap
From A.09.10
may occur
during the
measurement.
The instrument
may seem to
pause during
the
measurement.
(System
key.
Preset
>
> Service