Creating Loss Compensation Table; Saving Loss Compensation Table - Agilent Technologies E5071C Manual

Hide thumbs Also See for E5071C:

Table of Contents

4. Click Loss Compen > Compensation. Each press toggles the selection

between ON/OFF.

Creating loss compensation table

Follow the steps below to set the loss compensation table.

2. Click Power Calibration.

3. Select a port (refer to Selecting target port of error correction).

4. Click Loss Compen

5. Set the frequency (Frequency) and the loss (Loss) of the loss

compensation table by using the hardkeys and softkeys.

reference calibration factor and the calibration factor table.

2. For a frequency other than one set in the table, a value

obtained by linear interpolation of the calibration factors at the

2 points adjacent to the frequency is used. If a frequency is

lower than the lowest frequency in the table, the calibration

factor at the lowest frequency is used; if larger than the highest

frequency in the table, the calibration factor at the highest

frequency is used.

3. When setting the table by using the front panel keys or the

keyboard, you need to first set the focus on (select) the

operation target (table or softkey). You can change the focus by

placed on the table, the window frame of the table is displayed

as bright as the window frame of the active channel. When the

focus is placed on the softkey menu, the softkey menu title area

is displayed in blue.

You can save the loss compensation table as a CSV (Comma Separated

Value) format file.

2. Click Power Calibration.

3. Select a port (refer to Selecting target port of error correction).

4. Click Loss Compen.

5. Click Export to CSV File to open the Save As dialog box. At this time,

CSV File (extension*.csv) is selected as the file type.

> OK does not affect the current setting of the

key in the ENTRY block. When the focus is

Show Quick Links

Table of Contents