Agilent Technologies E5071C Manual page 545

E5071C
51 Specified trace
dose not exist
26 Standard not
selected
-150 String data error
-158
String data not
allowed
-138
Suffix not
allowed
-134 Suffix too long
55 Sweep mode
changed to
stepped sweep.
772
avoid duplication of ports. This error is
not generated by front key operations.
This error occurs when CALC:PAR:SEL
command is executed to activate more
traces than specified by
CALC:PAR:COUN command. This error
is not generated by front key
operations.
This error occurs when you execute
the measurement under the condition
that the standard is not selected for
the subclass (the standard number is
set to 0).
When a character-string-data element
is put to syntactic analysis, an error
not corresponding to one of Error
Numbers -151 through -159 occurs.
A character-string-data element has
been received at a position where this
instrument does not accept one.
A suffix is attached to a numeric value
element to which a suffix is not
allowed to be attached.
The unit is too long.
The unit is expressed in 12 or more
characters (see 7.7.3.4, IEEE488.2).
You cannot change the sweep mode to
the swept mode. This error occurs
when you change the sweep mode to
the swept mode/high speed swept
mode under the conditions where the
sweep type is set to power sweep,
power slope function is enabled (ON,
correction coefficient is other than
zero), power calibration is ON,
frequency offset is enabled, spurious
avoidance of frequency offset is
enabled, or external signal source