Agilent Technologies E5071C Manual page 839

E5071C
To select a circuit type, use the following command:
:CALC{1-36}:FSIM:SEND:PMC:PORT{1-4}
To set the circuit constant, use the following commands:
Circuit constant
C
G
L
R
When you want to use a user file to define the circuit type, specify the file
by using the following command:
:CALC{1-36}:FSIM:SEND:PMC:PORT{1-4}:USER:FIL
Port Impedance Conversion
The Port Impedance Conversion feature converts the measurement results
with a port impedance of 50 ohm to the characteristics of a different port
impedance.
On/Off
To turn on or off Port Impedance Conversion, use the following command:
:CALC{1-36}:FSIM:SEND:ZCON:STAT
You can only turn on or off Port Impedance Conversion for all of the ports,
not for each port individually. However, any port with ZO set to 50
ohm behaves as if this feature were permanently off.
Setting the Z0 Value
To set the target port impedance, use the following command:
:CALC{1-36}:FSIM:SEND:ZCON:PORT{1-4}:Z0
:CALC{1-36}:FSIM:SEND:ZCON:PORT{1-4}:REAL
:CALC{1-36}:FSIM:SEND:ZCON:PORT{1-4}:IMAG
Network De-embedding
The Network De-embedding feature eliminates any network that can cause
error between the calibration level and the DUT.
On/Off
To turn on or off Network De-embedding, use the following command:
:CALC{1-36}:FSIM:SEND:DEEM:STAT
1066
Command
:CALC{1-36}:FSIM:SEND:PMC:PORT{1-4}:PAR:C
:CALC{1-36}:FSIM:SEND:PMC:PORT{1-4}:PAR:G
:CALC{1-36}:FSIM:SEND:PMC:PORT{1-4}:PAR:L
:CALC{1-36}:FSIM:SEND:PMC:PORT{1-4}:PAR:R