Setting Up The Sweep Time (Manual Sweep Time Mode); Switching To Automatic Sweep Time Mode - Agilent Technologies E5071C Manual

The following figure shows the definitions of the sweep time and the sweep
delay time.
Sweep delay is time before starting a sweep for each stimulus (source)
port

Setting Up the Sweep Time (Manual Sweep Time Mode)

1. Press
Channel Next/Channel Prev
2. Press
Sweep Setup
3. Using the
sweep time (in seconds).
If the previous operation mode was automatic sweep time mode, entering
a new sweep time forces the analyzer to switch to manual sweep time
mode.

Switching to Automatic Sweep Time Mode

1. Press
Channel Next/Channel Prev
2. Press
Sweep Setup
By entering zero (seconds), automatic sweep time becomes effective.
key, then Click Sweep Time.
block keys on the front panel, input the desired
ENTRY
key, then click Sweep Time, press
keys to select the desired channel.
keys to select the desired channel.
Measurement
> x1.
0
93