Agilent Technologies E5071C Manual page 853

Hide thumbs Also See for E5071C:

Table of Contents

for the respective channels; for example, you can obtain the test result for

channel 15 from bit 1 and that for channel 16 from bit 2.

Every bit of the condition register is set to 0 after the event registers are

cleared by the *CLS. Upon completion of measurement, if the channel-wide

test result that combines the results for all traces in a channel is "fail," the

corresponding bit of the condition register is set to 1.

If the corresponding bit of the positive transition filter is set to 1 (preset

value), every bit of the event register is set to 1 when the corresponding

bit of the condition register changes from 0 to 1.

To retrieve the registers, use the following commands:

Questionable limit status register

Condition register

Event register

Questionable limit extra status register

Condition register

Event register

Obtaining test results for a channel (channel 1 in this example) using the status register

:STAT:QUES:LIM:COND?

:STAT:QUES:LIM?

:STAT:QUES:LIM:ELIM:COND?

:STAT:QUES:LIM:ELIM?

Show Quick Links

Table of Contents