Agilent Technologies E5071C Manual page 535

E5071C
allowed
H
No. Message
-114 Header suffix
out of range
I
No. Message
-224 Illegal
parameter
value
-282 Illegal
program
name
-213 Init ignored
35 Insufficient
ECal module
memory
-161 Invalid block
data
28 Invalid
calibration
method
-101 Invalid
character
762
IEEE488.2).
Description
The unit of the header is outside the range.
The header is invalid in the unit for numeric
parameters following a SCPI command.
Description
The parameter value is not suitable. This
error occurs when the CALC:PAR:DEF
command is used to specify an S-parameter
that does not exist in the model (S44 in the
case of a 2-port model), for example.
This error occurs when a nonexistent VBA
program name is specified by the
PROG:SEL:NAME command.
Because another measurement is in
progress, the request for initiating a
measurement ("INIT" command) is ignored.
This error occurs when the embedded
memory is insufficient to save the user
property in ECal module during the user
definition ECal processing.
Block data has been expected, but the block
data that appears is invalid for some reason
(see 7.7.6.2, IEEE488.2). The END message
is received before the length of block data
has been filled, for example.
This error occurs when the type of
calibration is not specified or not correct
when partial overwrite is executed with the
GPIB command. This error does not occur
for operation with front keys.
An invalid character exists in the program
message character string.