Using :Trig:sing Command; Using Wait Time - Agilent Technologies E5071C Manual

Sample Program
See the Waiting for Trigger (SRQ).

Using :TRIG:SING Command

When you trigger the instrument by issuing the
can use the *OPC command to wait until the measurement cycle is
completed.
Sample Program
See the Waiting for Trigger (OPC?).

Using Wait Time

Before creating your program, actually measure the time between the start
and end of the measurement cycle. Then code your program so that the
controller waits for the actually measured time by using the appropriate
command (for example, the WAIT command for HTBasic). This is a
straightforward method, but care must be taken: an incorrect wait time
could result in an unexpected error.
Programming
command, you
:TRIG:SING
1039