Setting Stimulus Conditions; Setting Sweep Type; Setting The Sweep Range - Agilent Technologies ENA Series User Manual

Rf network analyzers

Hide thumbs Also See for ENA Series:

Table of Contents

Setting Measurement Conditions

Setting Stimulus Conditions

You can set the stimulus condition for each channel independently.

You can select the sweep type from the following four types.

The procedure for selecting the sweep type is as follows:

Step 1. Press

Step 2. Press

Step 3. Press

Step 4. Press the desired softkey to select the sweep type.

There are two ways to set the sweep range: by specifying the lowest and the highest values

and by specifying the center value and a span. Once the sweep range is set, it is possible to

change the range by substituting the lowest value, the highest value, or the center value

with a value (stimulus value) represented by a marker on the trace.

Setting the sweep range

Sweeps frequencies in linear scale.

Sweeps frequencies in logarithmic scale.

Performs a sweep with linear sweep conditions (segments) combined. For

more information, refer to "Performing a Segment-by-Segment Sweep

(segment sweep)" on page 415.

Sweeps power levels in linear scale.

to select the channel for which you want to set the

E5070b E5071b