Ruijie Networks RG-S2600E Series Cli Reference Manual page 94

S2600E/P CLI Reference Guide
Command
mode
Usage
guidelines
Examples
Related
commands
1.1.14 shutdown
Use the shutdown command in the interface configuration mode to disable an
interface. Use the no form of the command to enable a disabled port.
shutdown
no shutdown
Command
mode
Usage
guidelines
Examples
Related
comman
ds
Chapter 1 Interface Configuration Commands
Interface configuration mode.
Set the maximum transmission unit (MTU) supported on
the interface. S8600 series now supports the setting on
physical interfaces.
Ruijie(config)# interface gigabitethernet 1/1
Ruijie(config-if)# mtu 9216
Command
show
interfaces
Interface configuration mode
Use this command to stop the forwarding on the interface
(Gigabit Ethernet interface, Aggregate port or SVI). You
can enable the port with the no shutdown command. If
you shut down the interface, the configuration of the
interface exists, but does not take effect. You can view the
interface status by using the show interfaces command.
Shut down Ap 1:
Ruijie(config)# interface aggregateport 1
Ruijie(config-if)# shutdown
Enable Ap 1:
Ruijie(config)# interface aggregateport 1
Ruijie(config-if)# no shutdown
Command
clear interface
Description
Show the interface information.
Description
Reset the hardware.