Ruijie Networks RG-S2600E Series Cli Reference Manual page 462

S2600E/P CLI Reference Guide
Command
mode
Usage
guidelines
Examples
Related
commands
2.1.10 ipv6 mld snooping vla
U se this comm
command to delete a
ipv6 mld snooping vlan vid mrouter interface interface-id
n o ipv6 m
Parameter
description
Default
Settings
Global configuration mode.
The mrouter interface is the interface of the multicast
device connected with the peer device. By default, the
dynamically-learned mroute interface is enabled on the
layer-2 multicast device. Use the no option to disable this
function
interfaces. With the source port check enabled, only the
multicast flow through the mroute interface are valid and
forwarded to the registered interface on the layer-2
multicast device. Those multicast flow through the
non-mroute interface are invalid and will be discarded.
With the source port check function enabled, use the
dynamically-
snooping flexibility.
T he followin
multicast route port learn function:
Ruijie(config)# ipv6 ml
Command
ipv6 mld snooping
vlan
interface
n mrouter
and to set the static mro
static mrouter inte face.
ld snooping vlan vid mrouter interface interface-id
Parameter
vid
Interface-id
N/A.
Chapter 2 MLD Snooping Commands
and clear all dynamically-learned
learned m route interfac
g example shows how to enable the
d snooping vlan 1 mrouter learn
Description
mrouter
Set the mrouter inte
interfa ce
uter interf ace. Use the no form of this
r
Description
The vlan id, with the valid range
1-4094.
The interfa ce number.
mroute
es to improve the mld
dynamic
rface.