Ruijie Networks RG-S2600E Series Cli Reference Manual page 958

S2600E CLI Reference Guide
Default
Command
mode
Usage
guidelines
Examples
Related
commands
1.1.6 mac-aadress-table move update receive
Use this command to enable REUP to receive the mac-address-table update
messages.
mac-address-table move update receive
no mac-address-table move update receive
Chapter 1 REUP Configuration Commands
The preemption function is disabled by default.
The default preemption delay time is 35s.
Interface configuration mode.
The preemption mode includes forced, bandwidth and
off. In the bandwidth preemption mode, the interface with
high bandwidth has priority over other interfaces to
transmit the data. In the forced preemption mode, the
primary has priority over backup interfaces to transmit the
data. No preemption event occurrs in the off preemption
mode. By default, the preemption mode is off.
The preemption delay refers to the delay time of the link
reswitch after the restoration of the link failure.
The following example shows how to set the dual link
backup, with fa 0/1 and fa 0/2 as the primary interface and
backup interface, set the bandwidth preemption mode and
40s preemption delay:
Ruijie(config)# interface fa 0/1
Ruijie(config-if)# switchport backup interface fa 0/2
preemption mode bandwitdh
Ruijie(config-if)# switchport backup interface fa 0/2
preemption delay 40
Command Description
show interface
switchport View the dual link backup configuration.
backup