Ruijie Networks RG-S2600E Series Cli Reference Manual page 37

S2600E/P CLI Reference Guide
Commands
Examples
2.2.11
To set speed at which the terminal transmits packets, execute the speed speed
command in the line configuration mode. To restore the speed to its default
value, run the no speed command.
speed speed
Parameter
description
Command
mode
Default
Configuration
Usage
guidelines
Examples
2.2.12
To perform the read/write operation for the device configurations (startup
configuration or system configuration), execute the privileged user command
write .
write [ memory | network | terminal ]
The example below specifies the timeout of session is 5
minutes.
Ruijie(config-line)#exec-timeout 5 output
speed
Parameter
speed
Global configuration mode.
The default rate is 9600.
This command sets the speed at which the terminal
transmits packets.
The following example shows how to configure the rate of
the serial port to 57600 bps:
Ruijie(config)#
Ruijie(config)# line console 0
Ruijie(config-line)# speed 57600
Ruijie(config-line)#
write
Chapter 2 Switch Management Configuration
Description
Transmission rate (bps) on the terminal.
For serial ports, the optional rates are
9600, 19200, 38400, 57600, and 115200
bps. The default rate is 9600 bps.