Ruijie Networks RG-S2600E Series Cli Reference Manual page 228

S2600E/P CLI Reference Guide
Parameter
description
Command
mode
Examples
Related
commands
Platform
description
12.1.4 switchport mode dot1q-tunnel
Use this command to configure the interface as the dot1q-tunnel interface.
switchport mode dot1q-tunnel
no switchport mode
Parameter
description
Default
configuration
Command
mode
Examples
Chapter 12 QinQ Configuration Commands
Parameter
no
Interface configuration mode.
Ruijie(config)# interface gigabitEthernet 0/2
Ruijie(config-if)# inner-priority-trust enable
Command
show
inner-priority-trust
-
Parameter
no
No dot1q-tunnel interface is configured.
Interface configuration mode.
Here is an example of configuring the interface as the
dot1q-tunnel interface:
Ruijie(config)# interface gi 0/1
Ruijie(config-if)# switchport access vlan 22
Ruijie(config-if)# switchport mode dot1q-tunnel
Ruijie(config)# end
Description
Remove the settings.
Description
-
Description
Delete the corresponding
dot1q-tunnel
configuration.
interface