Ruijie Networks RG-S2600E Series Cli Reference Manual page 820

S2600E CLI Reference Guide
15.5.10 nfpp icmp-guard
isolate-period
Use this command to set the isolate period in the interface configuration mode.
nfpp icmp-guard isolate-period {seconds | permanent}
Parameter
description
Default
Settings
Command
mode
Usage
guidelines
Examples
Related
commands
15.5.11 nfpp icmp-guard policy
Use this command to set the rate-limit threshold and the attack threshold.
nfpp icmp-guard policy { per-src-ip | per-port} rate-limit-pps attack-threshold-pps
Chapter 15 NFPP Configuration Commands
Parameter Description
Set the isolate period, in second. The
seconds
valid range is 0, or [30, 86400]. 0
indicates no isolation.
permanent
Permanent isolation.
By default, the isolate period is not configured.
Interface configuration mode.
N/A
Ruijie(config)# interface G0/1
Ruijie(config-if)# nfpp icmp-guard isolate-period 180
Command
icmp-guard
isolate-period
show nfpp
icmp-guard
summary
Description
Set the global isolate period.
Show the configurations.