Ruijie Networks RG-S2600E Series Cli Reference Manual page 466

S2600E/P CLI Reference Guide
Parameter
description
Default
Settings
Command
mode
Usage
guidelines
Examples
2.1.15 ipv6 mld sn
U se this com
configuration mode. Use the no form of this command to delete the associated
profile.
ip v6 mld sn
no ipv6 mld snooping filter profile-number
Parameter
description
Parameter
-
N/A
Global config
The MLD Snooping source port check function is to limit
the MLD multicast flow
the source port check disabled, all video flow are illegal
and forwarded to the registered member port according to
the MLD Snooping forwarding list. With the MLD Snooping
source port c
the mroute interface is legal and forwarded to the
registered interface by the layer-2 multicast device; and
the multicast flow through the non-mroute interface are
illegal and discarded.
This command is used to enabled the source port check
glo bally. Once this function is enabld, all multicast flow
must come from the mroute interface, or they'll be
discarded.
The following example shows how to enable mld snooping
source-check port:
Ruijie(config-if)# ipv6 mld snooping source-check port
oop ing fil ter
mand to filter the
ooping filter p rofile-number
Parameter
profile-number
Chapter 2 MLD Snooping Commands
Description
-
uration mode.
through the interace strictly. With
heck enabled, only the mulitcast flow through
spe cific multicast flow in
Description
Set the profile number.
the interface