S2600E/P CLI Reference Guide
Default
Settings
Command
mode
Usage
guidelines
Examples
Related
commands
2.1.16
ipv6
mld snoop
U
se this comm
dynamically in the interface configuration mode. Use the no form of this
command to cancel the limit.
ip
v6 mld sn
no ipv6 mld snooping max-groups
Parameter
description
Default
Settings
Command
mode
N/A.
Interface configuration mode.
You can configure an MLD Profile
MLD Report packets are received on the in
layer-2 device will determine whether the
address to be joined the interface is within the allowed
range of the MLD Profile. The specified profile must be
created befo
The following example shows how to associate profile1
with the inte
rface fastEthernet 0/1:
Ruijie(config)# interface fastEthernet 0/1
Ruijie(config-if)# ipv6 mld snooping filter 1
Command
ipv6 mld profile
ing ma
x-groups
and
to set th
e maximum
ooping max-groups number
Parameter
number
1
024
Interface configuration mode.
Chapter 2 MLD Snooping Commands
re using t
his command.
Description
Create a profile.
group allowed to join th
Description
The valid range is 0-1024.
on an interface. If the
terface, the
multicast
e interface
Need help?
Do you have a question about the RG-S2600E Series and is the answer not in the manual?