Ruijie Networks RG-S2600E Series Cli Reference Manual page 738

S2600E CLI Reference Guide
Related
commands
11.2 Commands for
Configuring the L2 Port to a
Trusted Port
11.2.1 ip arp inspection trust
Use this command to configure the L2 port to a trusted port.The no option of this command will
restore the L2 port to a untrusted port.
ip arp inspection trust
no ip arp inspection trust
Default
configuration
Command
mode
Usage
guidelines
Examples
Related
commands
Chapter 11 DAI Configuration Commands
Command Description
Show the information of the DAI
show ip arp
inspection function of the specified
inspection vlan
VLAN.
The L2 port is a untrusted port.
Interface configuration mode.
If it is necessary to make the ARP message received by
some interface pass the DAI inspection unconditionally,
you can set the interface to a trusted port, indicating that
you do not need to check whether the ARP message
received by this interface is legal.
The configuration example below sets the gigabitEthernet
0/19 interface as the trusted port.
Ruijie(config)# interface gigabitEthernet 0/19
Ruijie(config-if)# ip arp inspection trust
Command
show ip arp inspection
interface
Description
Show related DAI information
on the interface, including the
trust state and rate limit of the
interface.