Ruijie Networks RG-S2600E Series Cli Reference Manual page 678

S2600E CLI Reference Guide
Examples
Related
commands
7.1.10 switchport port-security
maximum
Use this command to set the maximum number of the port secure address.. Use the no form
of the command to restore it to the default setting.
switchport port-security maximum value
[no] switchport port-security maximum
Parameter
description
Chapter 7 Port-based Flow Control Configuration Commands
The example below describes how to configure a static secure
address 00d0.f800.5555 with VID 2 for the trunk port g 0/10:
Ruijie(config)#inter g0/10
Ruijie(config-if)# switchport port-security mac-address
00d0.f800.5555 vlan 2
The example below describes how to enable the Sticky MAC
address learning on the interface g0/10
Ruijie(config)#inter g0/10
Ruijie(config-if)# switchport port-security sticky
mac-address
Command
show port-security
switchport
port-security
switchport
port-security binding
switchport
port-security
mac-address interface
switchport
port-security
mac-address
switchport
port-security aging
Parameter
value
:
Description
Show port security settings.
Enable the port-security.
Configure the secure address
binding.
Set the static secure address in
the privileged mode.
Set the static secure address in
the interface configuration
mode.
Set the aging time for the
secure address.
Description
Maximum number of the secure
address, in the range of 1 to
128.