Ruijie Networks RG-S2600E Series Cli Reference Manual page 948

S2600E CLI Reference Guide
Command
mode
Usage
guidelines
Examples
Related
commands
Platform
description
2.3 Showing Related Command
2.3.1 show class-map
Use this command to show the information of class maps.
show class-map [class -name]
Parameter
description
Default
configuration
Chapter 2 QoS Configuration Command
Interface configuration mode.
The member port joined the virtual group must be physical
port or Aggregate Port. The virtual group member ports
must be in the same line card(for the chassis-shaped
switch) or in the same switch(for the box-shaped switch). If
the line card or switch has 48 ports, then all member ports
shall be distributed on the former 24 ports or the latter 24
ports.
The following example sets the interface gigabitEthernet
1/3 as the member of virtual group 3:
Ruijie(config)# interface gigabitethernet 1/3
Ruijie(config-if)# virtual-group 3
Command Description
show Show the virtual-group settings.
virtual-group
The software version must be RGOS10.1 and higher.
Parameter Description
class-name Name of the class map
All class maps are shown by default.