Ruijie Networks RG-S2600E Series Cli Reference Manual page 444

S2600E/P CLI Reference Guide
Parameter
description
Default
Command
mode
Usage
guidelines
Examples
Related
commands
1.1.32 range
To specify the range of multicast streams, execute the range command in the
profile configuration mode. You can specify either a single multicast address or
a range of multicast addresses. Use the no form of the command to remove the
specified multicast IP address.
range low-ip-address [high-ip-address]
no range low-ip-address [high-ip-address]
Parameter
description
Default
Chapter 1 IGMP Snooping Commands
N/ A
The forwarding of the multicast streams in the range
specified by the profile is denied.
Profile configuration mode.
First, configure the multicast range using the range
command in the profile configuration mode. In addition, the
profile must be applied to the interface in order to make the
profile configuration to take effective.
The following is an example of allowing the forwarding of
the multicast stream 224.2.2.2:
Ruijie(config)# ip igmp profile 1
Ruijie(config-profile)# range 224.2.2.2
Ruijie(config-profile)# permit
Command Description
ip igmp profile Create a profile.
range Configure the multicast address range.
Parameter Description
low-ip-address Start address of a range
high-ip-address End address of a range
N/A.