Ruijie Networks RG-S2600E Series Cli Reference Manual page 139

S2600E/P CLI Reference Guide
4
4.1 Configuration Related Commands
4.1.1 port-group mode
Use this command to enable LACP and specify the group ID and the
aggregation mode. Use the no form of this command to disable the LACP.
port-group key mode {active | passive}
no port-group
Parameter
description
Default
configuration
Command
mode
Usage
LACP
Commands
Parameter
key
active
passive
By default, the LACP function is disabled on the
Interface configuration mode.
N/A
Chapter 4 LACP Configuration Commands
Configuration
Description
Specify the group ID on the port to be
aggregated. The key values vary with
the aggregation
supported for different products.
Places a port into an active negotiating
state, in which
negotiations with remote ports by
sending LACP packets.
Places a port into a passive negotiating
state, in which the port responds to
LACP packets it receives but does not
initiate LACP negotiation.
group numbers
the port initiates
interface.