Ruijie Networks RG-S2600E Series Cli Reference Manual page 679

S2600E CLI Reference Guide
Default
configuration
Command
mode
Usage
guidelines
Examples
Related
commands
7.1.11 nac-author-user maximum
Use this command to set the limited number of port IP address. Use the no form of the
command to disable the port IP address number limit.
nac-author-user maximum value
[no] nac-author-user maximum
Parameter
description
Chapter 7 Port-based Flow Control Configuration Commands
128
Interface configuration mode.
The number of the secure address contains the sum of static secure
address and dynamically learnt secure address, 128 by default. If the
number of the secure address you set is less than current number, it
will prompt this setting fails.
The example below describes how to set the maximum number of the
secure address as 2 for interface g 0/10
Ruijie(config)#inter g0/10
Ruijie(config-if)# switchport port-security maximum 2
Command
show port-security
switchport port-security
switchport port-security
binding
Switchport port-security
mac-address
switchport port-security aging
Parameter
value
Description
Show port
settings.
Enable the
port-security.
Configure the secure
address binding.
Set the static secure
address in the interface
configuration mode.
Set the aging time for
the port
address.
Description
The limited IP address number
in the range of 1 to 1024.
security
secure