Ruijie Networks RG-S2600E Series Cli Reference Manual page 341

S2600E CLI Reference Guide
Default
configuration
Command
mode
Examples
Related
commands
1.1.7 snmp-server host
Use this command to specify the SNMP host (NMS) to send the trap message
in the global configuration mode. The no form of this command is used to
remove the specified SNMP host.
snmp-server host {host-addr| ipv6 ipv6-addr} [vrf vrfname] [traps] [version {1
| 2c
port-num][notification-type]
no snmp-server host { host-addr | ipv6 ipv6-addr } [ vrf vrfname ] [ traps ]
[ version { 1 | 2c | 3 { auth | noauth | priv } ] community-string [ udp-port
port-num ]
Parameter
description
Chapter 1 SNMP Configuration Command
ipv6_aclname
writeview
N/A.
Global configuration mode.
The example below sets a user group.
Ruijie(config)# snmp-server group mib2user v3 priv read
mib2
Command
show
group
| 3 [auth | noauth
Parameter
host-addr
ipv6-addr
vrfname
version
auth | noauth |
priv
are permitted to access the MIB.
Name of the IPv6 ACL, which specifies
the IPv6 address range of the NMS that
are permitted to access the MIB
Associate with a read-write view.
Description
snmp Show the
configuration.
| priv]] community-string
Description
SNMP host address
SNMP host address(ipv6)
Set the name of vrf forwarding table
SNMP version: V1, V2C or V3
Security level of SNMPv3 users
SNMP user group
[udp-port