Ruijie Networks RG-S2600E Series Cli Reference Manual page 77

S2600E/P CLI Reference Guide
Configuration Commands
5.1.2
Use this command to test the connectivity of a network to locate the network
connectivity problem. The command format is as follows:
ping [ipv6] [ipv6-address [length length ] [ntimes times] [timeout seconds]
[data data] [source source]
Parameter
description
Default
Command
mode
ping ipv6
Parameter
Ipv6-address
length
times
seconds
data
source
Five packets with 100Byte in length are sent to the
specified IP address within specified time (2s by default).
Privileged mode.
Chapter 5 Network Connectivity Test Tool
Description
Specifies an IPv6 address.
Specifies the length of the packet to be
sent.
Specifies the number of packets to be
sent.
Specifies the timeout time.
Specifies the data to fill in.
Specifies the source IPv6 address or
the source interface. The loopback
interface address(for
127.0.0.1) is not allowed to be the
source address.
example: