Ruijie Networks RG-S2600E Series Cli Reference Manual page 460

S2600E/P CLI Reference Guide
2.1.7 ipv 6 mld snooping query-max-response-time
Use this command to set t the maximum response time of the MLD general
query packet. Use th
i pv6 mld snooping quer
no ipv6 mld snooping query-max-response
Parameter
description
Default
Settings
Command
mode
Usage
guidelines
Examples
Chapter 2 MLD Snooping Commands
e no form of this com mand to resto
y-max-respons e-time time
Parameter Description
Set the maximum response time of
time the MLD general query packet, in
seconds. The valid range is 1-65535.
10s.
Global configuration mode.
Upon receiving the MLD general query packets, the
Layer-2 multicast device updates the aging timer of all
member ports. The time of the timer is the
response value. When the timer value decreases to 0, it
indicates that there is no member receiving the multicast
flow on the interface, and the Layer-2 device removes this
interface from the MLD Snooping forwarding list.
Upon receiving the MLD specific group query packets, the
Layer-2 multicast device enables the aging timer of all
member ports in this specific group. The time of the timer
is the longest response
decreases to 0, it indicates that there is no member
receiving the multicast fl
Layer-2 device removes this interface from the MLD
Snooping forwarding list.
For the source query packets of the MLD specific grou
the timer is not updated.
The following example shows how to set the maximum
res ponse time of the MLD general query packet as 15s:
Ruijie(config)# ipv6 mld snooping
query-max-response-time 15
re it to the default value.
-time
value. When the timer value
ow on the interface, and the
longest
p,