Ruijie Networks RG-S2600E Series Cli Reference Manual page 581

S2600E CLI Reference Guide
Ruijie#
Command
Related
show
commands
private-supplicant-only
4.5.19 dot1x port-control auto
In the interface configuration mode, use this command to allow the port to participate in
authentication. Use the no form of the command to restore it to the default value.
dot1x port-control auto
no dot1x port-control
Parameter
description N/A.
By default, the port does not participate in 802.1x
Default
authentication.
Command
mode Interface configuration mode.
Usage Use the show dot1x command to show the 802.1X
configuration.
guidelines
The following example sets the port to participate in
authentication:
Ruijie# configure terminal
Examples
Ruijie(config)# interface g0/1
Ruijie(config-if)# dot1x port-control auto
Ruijie(config-if)# end
Ruijie#
Command
Related
commands
show dot1x
Chapter 4 802.1X Configuration Commands
Function
dot1x Show the information about
the private supplicant.
Description
Show the information about 802.1x.