Ruijie Networks RG-S2600E Series Cli Reference Manual page 553

S2600E CLI Reference Guide
commands
show dot1x
auto-req
4.1.2 dot1x auto-req
packet-num
Use this command to set the number of authentication request messages that the device
automatically sends. The no form is used to specify the default value.
dot1x auto-req packet-num num
no dot1x auto-req packet-num
Parameter
Parameter
description
num
Default num = 0; namely the packets are sent continuously.
Command
Global configuration mode.
mode
Usage Use the show dot1x auto-req command to view the
guidelines setting of this function.
The following example sets the device to automatically
initiate 802.1x authentication continuously:
Ruijie# configure terminal
Ruijie(config)# dot1x auto-req packet-num 0
Ruijie(config)# end
Examples
Ruijie# show dot1x auto-req
Auto-Req: Enabled
User-Detect : Enabled
Packet-Num : 0
Req-Interval: 30 Second
Command
Related
show dot1x
commands
auto-req
Chapter 4 802.1X Configuration Commands
Show the automatic authentication
request information.
Description
Number of authentication
messages that
automatically.
Description
Show the authentication request
information.
request
the device sends