Ruijie Networks RG-S2600E Series Cli Reference Manual page 535

S2600E CLI Reference Guide
2.1.8 radius-server deadtime
The global configuration command is used to configure the duration when a device stops
sending any requests to an unreachable Radius server. The no form of this command is used
to recover the default value.
radius-server deadtime minnutes
no radius-server deadtime
Parameter
Parameter
description
minutes
The default value of minutes is 0 min, that is, the device
Default
keeps sending requests to the unreachable Radius server.
Command
Global configuration mode.
mode
If active Radius server detection is enabled on the device,
the time parameter of this command does not take effect
Usage
on the Radius server. Otherwise, the Radius server
guidelines
becomes reachable when the duration set by this
command is shorted than the unreachable time..
The following example sets the duration when the device
Examples
stops sending requests to 1 min.
Ruijie(config)# radius-server deadtime 1
Command
radius-server
Related
host
commands
radius-server
dead-criteria
2.1.9 radius attribute
radius attribute {id | down-rate-limit | dscp | mac-limit | up-rate-limit} vendor-type type
Chapter 2 RADIUS Configuration Commands
Description
Define the duration in minutes when the
device stops sending any requests to
the unreachable Radius server. The
value is in the range of 1 min to 1440
min (24h).
Description
Define the RADIUS security server.
Define the criteria to determine that a
Radius server is unreachable.