Ruijie Networks RG-S2600E Series Cli Reference Manual page 133

S2600E/P CLI Reference Guide
Commands
Usage
guidelines
Examples
Related
commands
Platform
description
3.1.2 port-group
Use this command to assign a physical interface to be a member port of an
aggregate port. Use the no form of the command to remove the membership
from the aggregate port.
port-group port-group-number
no port-group
Parameter
description
Default
configuration
Command
mode
Usage
guidelines
Examples
Chapter 3 Aggregate Port Configuration
Use show aggregateport to display load-balance
configuration.
Ruijie(config)# aggregateport load-balance dst-mac
Command Description
show
Use
aggregateport
aggregate port configurations.
load-balance
-
Parameter Description
Number of the member group of an
aggregate port, the interface number
port-group-number
of the aggregate port
By default, the physical port does not belong to any
aggregate port.
Interface configuration mode.
All the members of an aggregate port belong to a VLAN or
configured to be trunk ports. The ports belonging to
different native VLANs cannot form an aggregate port.
This example shows how to specify the Ethernet interface
1/3 and 1/4 as members of AP 3:
Ruijie(config)# interface gigabitethernet 1/3
Ruijie(config-if)# port-group 3
this command to display