Ruijie Networks RG-S2600E Series Cli Reference Manual page 20

S2600E/P CLI Reference Guide
Commands
Usage
guidelines
Examples
Related
commands
2.1.10
To specify the IP address of one interface as the source address for the Telnet
connection, use the ip telnet source-interface command in the global
configuration mode:
ip telnet source-interface interface-name
Parameter
description
Command
mode
Usage
guidelines
Examples
This command is used to configure the port for HTTPS
services. The no form of this command is used to restore
the default port configuration.
The example below sets the port for HTTPS services as
4443.
Ruijie(config)# ip http secure-port 4443
Command
enable service
show
web-server
status
ip telnet
source-interfa
ce
Keyword
interface-name Name of the specified interface
Global configuration mode.
This command is used to specify the IP address of one
interface as the source address for the global Telnet
connetction. When using the telnet command to log in a
Telnet server, if no source interface or source address is
specified for this connnetcion, the global setting is
used.Use the no ip telnet source-interface command to
restore it to the default setting.
The example below specifies the IP address of the
interface Loopback1 as the source address for the global
Telnet connection.
Ruijie(Config)# ip telnet source-interface Loopback 1
Chapter 2 Switch Management Configuration
Description
Enable or disable
service.
Show the status of the web server.
Description
the specified