Ruijie Networks RG-S2600E Series Cli Reference Manual page 787

S2600E CLI Reference Guide
Usage
guidelines
Examples
Related
commands
15.2.7 arp-guard scan-threshold
Use this command to set the global scan threshold.
arp-guard scan-threshold pkt-cnt
Parameter
description
Default
Settings
Command
mode
Usage
guidelines
Examples
Chapter 15 NFPP Configuration Commands
N/A
Ruijie(config)# nfpp
Ruijie(config-nfpp)# arp-guard rate-limit per-src-ip 2
Ruijie(config-nfpp)# arp-guard rate-limit per-src-mac 3
Ruijie(config-nfpp)# arp-guard rate-limit per-port 50
Command
nfpp arp-guard policy
show nfpp arp-guard
summary
Parameter
pkt-cnt
The default scan threshold is 15, in 10 seconds.
NFPP configuration mode.
The scanning may occur on the condition that:
more than 15 packets are received within 10 seconds;
the source MAC address for the link layer is constant while
the source IP address is uncertain;
the source MAC and IP address for the link layer is
constant while the destination IP address is uncertain.
Ruijie(config)# nfpp
Description
Set the rate limit and the attack
threshold.
Show the configurations.
Description
Set the scan threshold, in the
range of 1-9999.