Ruijie Networks RG-S2600E Series Cli Reference Manual page 14

S2600E/P CLI Reference Guide
Commands
Usage
guidelines
Examples
Related
commands
2.1.4
To configure the security password for different privilege level, execute the
global configuration command enable secret. The no form of this command is
used to delete the password of the specified level.
enable secret [level level] {secret | [0|5] encrypted-secret}
no enable secret
Parameter
description
No encryption is required in general. The encryption type is
required generally when the password that has been
encrypted with the command for the device are to be
copies and pasted.
The effective password is defined as below:

Consists of 1 ~ 26 letter in upeer/lower case and
numerals

Leading spaces are allowed but ignored. Spaces in
between or at the end are regarded as part of the
password.
Caution
The example below configures the password as pw10:
Ruijie(config)# enable password pw10
Command
enable secret
enable secret
Parameter
secret
level
0|5
encrypted-password
Chapter 2 Switch Management Configuration
If an encryption type is specified and then a
plaintext password is entered, it is
impossible to enter into the privileged
EXEC mode. A lost password that has
been encrypted with any method cannot be
restored. The only way is to reconfigure the
device password.
Description
Set the security password
Description
Password for user to enter into the
EXEC configuration layer
User's level.
Password encryption type, "0" for
no encryption, "5" for security
encryption
Password text