Ruijie Networks RG-S2600E Series Cli Reference Manual page 981

S2600E CLI Reference Guide
Commands
warm-reload {enable | count count-value |
Related
uptime uptime-value]
Commands
show warm-reload
None
Platform
Description
4.1.2 warm-reload
This command is used to configure the warm reload function in the global
configuration mode.
warm-reload {enable | count count-value | uptime uptime-value]
no warm-reload {enable | count | uptime}
enable
count count-value
Parameter
Description
uptime uptime-value
no
Default
Warm reload is disabled, count is 5, and uptime is 5 minutes.
Configuration
Command
Global configuration mode
Mode
Use Guide
Command
Parameter
Enable the warm reload function.
Configure the maximum times of successive warm reloads
between two cold reboots. The value is in the range from 1
to 50, and 5 by default.
Configure the minimum time interval from the moment when
the system becomes stable to warm reload. The value is in
the range from 0 to 120 minutes, and is 5 by default.
Restore the default configuration.
Warm reload cannot run until the configuration is saved and the
system is rebooted using Reload.
Note
Chapter 4 Warm Reload & Upgrade Configuration
Configure the warm reload function.
Show the operation history, current
state, and statistics of warm reload.
Description
Description