Ruijie Networks RG-S2600E Series Cli Reference Manual page 85

S2600E/P CLI Reference Guide
Usage
guidelines
Examples
1.1.2 clear counters
Use this command to clear the counters on the specified interface.
clear counters [interface-id]
Parameter
description
Command
mode
Usage
guidelines
Examples
Related
commands
Chapter 1 Interface Configuration Commands
This parameter refers to the delay after which the carrier
detection signal DCD of the interface link changes from the
Down status to the Up status. If the DCD changes within
the delay, the system will ignore such changes without
disconnecting the upeer data link layer for renegotiation.
If the DCD carrier is disconnected for a long time, the
parameter should be set longer to accelerate route
aggregation so that the routing table can be converged
more quickly. On the contrary, if the DCD carrier
interruption period is shorter than the time used for route
aggregation, you should set the parameter to a higher
value to avoid unnecessary route vibration.
The following example shows how to configure the carrier
delay of serial interface to 5 seconds:
Ruijie(config)# interface gigabitethernet 1/1
Ruijie(config)# carrier-delay 5
Parameter Description
Interface type and interface ID
interface-id
Privileged mode.
In the privileged EXEC mode, use the show interfaces
command to display the counters or the clear counters
command to clear the counters. If the interface is not
specified, the counters on all interfaces will be cleared.
Ruijie# clear counters gigabitethernet 1/1
Command Description
show
Show the interface information.
interfaces