Ruijie Networks RG-S2600E Series Cli Reference Manual page 960

S2600E CLI Reference Guide
Examples
Related
commands
1.1.8 mac-address-table move update transit
Use this command to enable REUP to transmit the mac-address-table update
messages.
mac-address-table move update transit
no mac-address-table move update transit
Default
Command
mode
Usage
guidelines
Examples
Related
commands
Chapter 1 REUP Configuration Commands
from processing MAC address update packets can still
recover downlink data transmission of the uplink device
using MAC address update packets, but the capability to
provide convergence on link failure will be degraded.
The following example configures VLANs processing MAC
address update packets:
Ruijie(config)# no mac-address-table move update receive
vlan 20
Command
mac-address-table
move update
receive
Disabled.
Global configuration mode.
In order to reduce the link switchover and the loss of the
downstream data flow, it is necessary to enable the switch
of receiving the MAC address update messages on the
uplink switch.
Ruijie(config)# mac-address-table move update transit
Command
mac-address-table
move update
transit vlan
Description
Enable REUP to receive MAC
address update packets.
Description
Enable REUP to
mac-address-table
messages.
transmit the
update