Ruijie Networks RG-S2600E Series Cli Reference Manual page 834

S2600E CLI Reference Guide
Command
mode
Usage
guidelines
Examples
Related
commands
15.7.9 global-policy
Use this command to set the rate-limit threshold and attack threshold based on the host or
port.
global-policy {per-src-mac | per-src-ip | per-port} rate-limit-pps attack-threshold-pps
Parameter
description
Chapter 15 NFPP Configuration Commands
NFPP define configuration mode.
The administrator can use this command to set the trusted
host free from monitoring. The ICMP packets are allowed
to sent to the trusted host CPU without any rate-limit and
warning configuration. Configure the mask to set all hosts
in one network segment free from monitoring.
UP to 500 trusted hosts are supported.
Before configuring the trusted-host, the match type must
be configured. If the message type configured by the
match is Ipv4, the Ipv6 trusted addresses are not allowed.
In the same way, if the message type is IPv6, the IPv4
trusted addresses are not allowed.
Ruijie(config)# nfpp
Ruijie(config-nfpp)# define tcp
Ruijie(config-nfpp-define)#trusted-host
255.255.255.255
Command
show nfpp define
trusted-host
Parameter
per-src-ip
per-src-mac
per-port
Description
Show the trusted
configurations.
Description
Perform the rate statistics based on
the source IP / VID and port.
Perform the rate statistics based on
the source MAC / VID and port.
Perform the rate statistics based on
each physical port of receiving the
1.1.1.1
host