Ruijie Networks RG-S2600E Series Cli Reference Manual page 902

S2600E CLI Reference Guide
Related
commands
Platform
description
1.1.8 ipv6 traffic-filter
Use this command to apply the specified IPV6 ACL on the specified interface.
Use the no form of the command to remove the application.
ipv6 traffic-filter name {in|out}
no ipv6 traffic-filter name {in | out}
Parameter
description
Default
configuration
Command
mode
Usage
guidelines
Examples
Chapter 1 ACL Configuration Commands
21 permit host 192.168.4.12
64 deny any any
Command Description
show Show the ACLs.
access-lists
The software version must be RGOS10.0 and higher.
Parameter Description
name Name of Ipv6 ACL
in Filter the incoming packets of the
interface
out Filter the outgoing packets of the
interface
No ACL is applied on the interface.
Interface configuration mode.
Apply the specified IPV6 ACL on the specified interface to
control the interface traffic. You can view the configuration
by command show ipv6 traffic-filter.
The following example shows how to apply the access-list
v6-acl to Gigabit interface Gigabit 0/1:
Ruijie(config)# interface GigaEthernet 0/1
Ruijie(config-if)# ipv6 traffic-filter v6-acl in