Ruijie Networks RG-S2600E Series Cli Reference Manual page 272

S2600E/P CLI Reference Guide
Examples
Related
commands
3.1.8 ipv6 nd managed-config-flag
Use this command to set the "managed address configuration" flag bit of the RA
message. Use the no form of this command to remove the setting.
ipv6 nd managed-config-flag
no ipv6 nd managed-config-flag
Default
configuration
Command
mode
Usage
guidelines
Examples
Related
commands
Chapter 3 IPv6 Configuration Commands
IPv6 operations on the interface). In this case, you shall
modify and configure a new address manually, and restart
address collision check for the down/up interface.
Whenever the state of an interface changes from down to
up, the address collision check function of the interface will
be enabled.
Ruijie(config-if)# ipv6 nd dad attempts 3
Command Description
show ipv6
Show the interface information.
interface
None.
Interface configuration mode.
This flag determines whether the host that receives the RA
message obtains an IP address through stateful auto
configuration. If the flag is set, the host obtains an IP
address through stateful auto configuration, otherwise it
does not be used.
Ruijie(config-if)# ipv6 nd managed-config-flag
Command Description
show ipv6
Show the interface information.
interface
Set
ipv6 nd
information except IP address through
other-config-flag
stateful auto configuration.
the flag for obtaining all