Ruijie Networks RG-S2600E Series Cli Reference Manual page 546

S2600E CLI Reference Guide
Command
aaa group
Related
server tacacs+
commands
ip vrf
forwarding
3.1.3 ip tacacs source-interface
Use this command to configure the source address of TACACS+ packet:
ip tacacs source-interface interface
no ip tacacs source-interface
Parameter
Parameter
interface
description
Default
The source address of TACACS+ packet is set on
network layer.
Configuration
Command
mode Global configuration mode.
To decrease the work of maintaining massive NAS
messages in TACACS+ server, use this command to set
the source address of TACACS+ packet. This command
Usage
specifies the first ip address of the specified interface as
guidelines
the source address of TACACS+ packet and is used on L3
devices.
The following example specifies TACACS+ packet to
obtain ip address from fastEthernet 0/0 as the source
address of TACACS+ packet :
Examples
Ruijie(config)# ip tacacs source-interface fastEthernet
0/0
Related Command
Chapter 3 TACACS+ Configuration Commands
Description
Configure TACACS+ server group.
Configure VRF name supported by
TACACS+ server group.
Description
Source address interface of TACACS+
packet
Description