Ruijie Networks RG-S2600E Series Cli Reference Manual page 73

S2600E/P CLI Reference Guide
default transport input
Parameter
description
Default
configuration
Command
mode
Usage
guidelines
Examples
Chapter 4 LINE Configuration Commands
Parameter Description
Allow all the protocols under Line to be
all
used for communication
Allow only the SSH protocol under Line
ssh
to be used for communication
Allow only the Telnet protocol under
telnet
Line to be used for communication
Allow none of protocols under Line to be
none
used for communication
By default, VTY allows all the protocols to be used for
communication. The default value of other types of TTYs
is NONE, indicating that no protocols are allowed for
communication. After some protocols are set to be
available for communication, use the default transport
input command to restore the setting to the default value.
Line configuration mode.
This command is used to set the protocols in the Line
mode that are available for communication. By default,
VTY allows all the protocols for communication. After
protocols available for communication are set, only these
protocols can connect on the specific VTY successfully.
Use the show running command to view configuration
information under Line.
Note: You can restore the default configuration by using
the default transport
transport input command is used to disable all the
communication protocols in the LINE mode. The setting
result is the same as that of transport input none.
Specify that only the Telnet protocol is allowed to login in
line vty 0 4:
Ruijie# configure terminal
Ruijie(config)# line vty 0 4
Ruijie(config-line)# transport input telnet
input command. The no