Ruijie Networks RG-S2600E Series Cli Reference Manual page 151

S2600E/P CLI Reference Guide
Command
mode
Usage
guidelines
Examples
Related
commands
5.1.6 vlan
Use this command to enter the VLAN configuration mode. Use the no form of
the command to remove the VLAN.
vlan vlan-id
Chapter 5 VLAN Configuration Commands
Interface configuration mode.
Native VLAN:
A trunk port belongs to one native VLAN. A native VLAN
means that the untagged packets received/sent on the
trunk port belong to the VLAN. Obviously, the default
VLAN ID of the interface (that is, the PVID in the IEEE
802.1Q) is the VLAN ID of the native VLAN. In addition,
when frames belonging to the native VLAN are sent over
the trunk port, they are untagged.
Allowed-VLAN List:
By default, a trunk port sends traffic to and received traffic
from all VLANs (ID 1 to 4094). However, you can prevent
the traffic from passing over the trunk port by configuring
allowed VLAN lists on a trunk port .
Use show interfaces switchport to display configuration.
The example below removes port 1/15 from VLAN 2:
Ruijie(config)# interface fastethernet 1/15
Ruijie(config-if)# switchport trunk allowed vlan remove
2
Ruijie(config-if)# end
Ruijie# show interfaces fastethernet1/15 switchport
Interface Switchport Mode Access Native Protected VLAN
lists
--------- --------- --------- ---------
FigabitEthernet 1/15 enabled TRUNK 1
1,3-4094
Command Description
show
Show the interface information.
interfaces
Use this command to configure an
switchport
interface as a statics access port and
access
assign it to a VLAN.
1 Disabled