Ipv6 Address Autoconfig - Ruijie Networks RG-S2600E Series Cli Reference Manual

S2600E/P CLI Reference Guide
3.1.2

ipv6 address autoconfig

Use this command to automatically configure an IPv6 stateless address for a
network interface. Use the no form of this command to delete the
auto-configured address.
ipv6 address autoconfig[default]
no ipv6 address autoconfig
Parameter
description
Command
mode
Usage
guidelines
Examples
Related
commands
Chapter 3 IPv6 Configuration Commands
Parameter
default
Interface configuration mode
The stateless automatic address configuration is that when
receiving the RA (Route Advertisement) message, the
device could use the prefix information of the RA message
to automatically generate the EUI-64 interface address.
If the RA message contains the flag of the "other
configurations", the interface will obtain these "other
configurations" through
configurations" usually means the IPv6 address of the
DNS server, the IPv6 address of the NTP server, etc.
Use the no ipv6 address autoconfig command to delete
the IPv6 address.
Ruijie(config-if)# ipv6 address autoconfig default
Ruijie(config-if)# no ipv6 address autoconfig
Command
ipv6 address
ipv6-prefix/prefix-length
[eui-64]
Description
(Optional) If this
configured, a default routing is
generated. Note that only one layer3
interface on the entire device is
allowed to use the default keyword.
the DHCPv6.
Description
Configure the IPv6 address for
the interface manually .
keyword is
The "other